CRITICAL NOTE ABOUT THE UPDATE: This update will take less than 10 minutes to complete. It includes both low-level firmware updates as well as security updates to the underlying operating system. Upon reboot, it may take several minutes for the system to start up while the operating system updates are applied, with both the STATUS and CAMSTAT LEDs flashing during this time.
DO NOT DISRUPT THE SYSTEM DURING THIS TIME.
NOTICE: Next release will remove Client support for processors running versions less than 19.3.
NEW: Added check box to "remember me" when logging in to a site within the client.
IMPROVEMENT: Improved informational text for zone recall behavior.
IMPROVEMENT: When FYA is selected in the Client, "FYA" will be displayed under the Phases button in the Configure view.
IMPROVEMENT: Improved clarity of the “Delete Stationary After” time range selection within the Client. “Never” has been more accurately named “2 Cycles.” For other values, units of time have been added.
FIX: Resolves a bug where toggling Client site connection to Off would forget previously entered credentials for the site.
FIX: Resolves a bug where publishing a zone configured with the default zone type of Other would be published as Stop-line instead.
FIX: Resolves a bug where updating from 19.12 to 20.10 would not update existing zones with assigned phases to Stop-line. Zones without assigned phases are updated to Other.
FIX: Corrected problem that frequently caused software restarts at night if a box zone was included in the site configuration.
- [KB4586823]- November 10, 2020—KB4586823 (Security-only update)